ComNav Marine 1420 Autopilot System
Adjust the position of the Outboard
Feedback so that the end of the sliding
rod is flush with the Stainless Bracket.
Screw the nut onto the threaded rod at
the end of the Outboard Feedback.
Adjust the position of the Outboard
Feedback so that as nearly as possible it
is parallel with the hydraulic cylinder both
horizontally and vertically. Tighten the
nuts and the stainless steel band clamp
securely.
Run the cable forward to the 1420
Processor location. Choose a route for
the cable so that the minimum bend
radius in the cable is at least 4.2” (10.7
cm). This is especially important in the
motor well and other areas where
vibration is present.
You will connect these wires to the
Processor when you make all the other
wiring connections.
Minimum Bend Radius
Maintenance
Keep the sliding rod clean. Wipe it occasionally so that dirt cannot enter the Linear
Feedback. Use a clean, soft rag.
After transporting your boat on a trailer, it is very important to clean the sliding rod!
Document PN 29010012 V1.3
21
To Next Page
Loading...
