ComNav Marine 1420 Autopilot System
Operation
The 1420 Second Station is identical in operation
4
to the main Control Head, as described
in the section Piloting with the 1420 Autopilot System.
Only one of the Control Heads can operate the autopilot at any time. The unit that is
non-active will have all 5 LEDs on at once.
To activate the non-active control, press and hold both the Red
& Green Keys. The
Control Head will come on in the same mode in which the previously active Control Head
was operating.
Turning the Autopilot On from the Second Station
To turn your 1420 on from either the Second Station Head or the main Head, press the
Pilot Key on that Head. The Autopilot will turn on, but always with the main Control Head
active. Then, press and hold the Red
& Green Keys to take control with the Second
Station.
Turning the Autopilot Off from the Main or Second Station
At the Head which is the active one, press and hold the Off key. Note that the 1420 cannot
be turned off from a Control Head which is not the active one.
4
Note: Setup cannot be done from the Second Station.
Document PN 29010012 V1.3
63
To Next Page
Loading...
