ComNav K Series - Page 22

22
K-series OEM Board User Guide
Log comX rtcm1005b ontime 5
Log comX rtcm1033b ontime 10
Saveconfig
// Base station coordinate
// Base station type
// Save configuration
RTCM3.2 (MSM4) For the Base
Unlogall
Fix position 31.1744880 121.3878091 44.1287
(Fix auto)
Log comX rtcm1074b ontime 1
Log comX rtcm1084b ontime 1
Log comX rtcm1094b ontime 1
Log comX rtcm1124b ontime 1
Log comX rtcm1005b ontime 5
Log comX rtcm1033b ontime 10
Saveconfig
// clear previous settings
// fix the entered coordinate
// fix the coordinate automatically
// GPS Full PRs and Phase Ranges plus CNR
// GLONASS Full PRs and Phase Ranges plus CNR
// GALILEO Full PRs and Phase Ranges plus CNR
// BeiDou Full PRs and Phase Ranges plus CNR
// Base station coordinate
// Base station type
// Save configuration
RTCM3.2 (MSM5) For the Base
Unlogall
Fix position 31.1744880 121.3878091 44.1287
(Fix auto)
Log comX rtcm1075b ontime 1
Log comX rtcm1085b ontime 1
Log comX rtcm1095b ontime 1
Log comX rtcm1125b ontime 1
Log comX rtcm1005b ontime 5
Log comX rtcm1033b ontime 10
Saveconfig
// clear previous settings
// fix the entered coordinate
// fix the coordinate automatically
// GPS Full PRs and Phase Ranges plus CNR
// GLONASS Full PRs and Phase Ranges plus CNR
// GALILEO Full PRs and Phase Ranges plus CNR
// BeiDou Full PRs and Phase Ranges plus CNR
// Base station coordinate
// Base station type
// Save configuration
For the Rover
For the Rover
log comX gpgga ontime 1
rtkobsmode 0
Interfacemode comX auto auto on
Saveconfig
//ComX output GPGGA data
//Set the observation mode of rover receiver
//Config comX to detect RTCM corrections
// Save configuration
Tip: If comX is the serial port used for configuration currently, please replace command saveconfig with
interfacemode saveconfig.