ComNav K Series - Frequently Used Commands; Check Version Information; Check Port Information; Change the Serial Port Baud Rate

28
K-series OEM Board User Guide
5. Frequently used commands
This section describes some frequently used commands for K-series OEM boards, such as version, raw data
and NMEA data output. For more programmatic commands, please refer to ComNav OEM Board Reference
Manual_V1.8.
5.1 Check version information
Log version //Version information about the board
5.2 Check port information
Log comconfig
//Log Information of the port
5.3 Change the serial port baud rate
Com comX 9600 //Change the baud rate of comX to 9600
Tip: after changing baud rate of current serial port, you need to reconnect your OEM board.