Compaq ArmadaStation - Service Considerations; Tool and Software Requirements; Screws

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Removal and Replacement Preliminaries
4-5
4.2 Service Considerations
Listed below are some of the considerations that you should keep in mind during the
disassembly and assembly of the ArmadaStation or Armada MiniStation.
Tool and Software Requirements
To service the ArmadaStation or Armada MiniStation, you need the following:
■
Torx T-8 screwdriver
■
Torx T-10 screwdriver (for memory door screw)
■
3/16-inch nut driver (for all screwlocks except docking connector)
■
7-mm hex socket (for docking connector screwlocks)
■
Connector removal tool
■
Display bezel removal tool
■
Diagnostics software
Screws
The screws used in the ArmadaStation or Armada MiniStation are not interchangeable.
If an incorrect screw is used during the reassembly process, it can damage the unit.
Compaq strongly recommends that all screws removed during disassembly be kept with
the part that was removed, then returned to their proper locations.
CAUTION:
When servicing the ArmadaStation or Armada MiniStation, ensure that all
screws are kept with the part with which they belong. Using an improper screw during
reassembly can damage the ArmadaStation or Armada MiniStation.
IMPORTANT: As each subassembly is removed from the ArmadaStation or Armada
MiniStation, it should be placed away from the work area to prevent damage.