Compaq External RAID Controller & Subsystem Infortrend - Page 340

Index-1
A
Access Mode: Read
Only or Read/Write
8-19
Active-to-Active
Configuration
10-11, 10-17
Active-to-Standby
Configuration
10-17
Adding a SCSI
Channel’s ID: LCD
5-26
Adding a SCSI ID:
terminal
7-26
Adding Drive to a
Logical Drive
12-4
Adding New Drive 12-4
Advanced Firmware
Features
B-2
Assign Spare Drives:
terminal
7-7
Assigning a Logical
Drive Name: LCD
5-18
Assigning Logical Drive
Name: terminal
7-17
Assigning Spare Drive:
LCD
5-14
Assigning Spare Drive:
terminal
7-15
Auto cache flush B-2
Auto recovery from
logical drive failure
B-2
Auto-Failback 10-11
Automatic engagement
of replacement
controller
B-7
automatic rebuild 1-9
Automatic Shutdown B-8
B
Background firmware
download
B-2
Bad block auto-
reassignment
B-7
Basic RAID
Management
B-1
Battery Support 10-17
Baud rate 3-1
beeper, mute 5-34, 7-34
C
Cache Dirty
Percentage: LCD
4-7
cache parameters 7-1~2
Cache Status 6-1
Cache Synchronization 10-17
caching parameters 7-1~2
Caching Parameters:
LCD
5-1, 5-3~4
Caching Parameters:
terminal
7-1
Change Password:
LCD
5-34
Change Password:
terminal
7-34
Channel failure
protection
1-14
Channel Mode B-5
channel mode,
redefining
7-25
Channel Mode: Fibre 8-6
channel mode: viewing
and redefining
5-25
check time, periodic
auto-detection of failed
drive swap
9-23
Choosing Member
Drives: LCD
5-6
Choosing Member
Drives: terminal
7-6
Choosing RAID Level:
terminal
7-6
Clone + Replace,
S.M.A.R.T.
9-6
Clone Failing Drive 9-2, B-8
Co-existing spares B-1
Index
IndexIndex
Index