Infortrend
Index-2
Communications
Channel: Fibre
8-7
Communications over
drive loops
8-13
concurrent rebuild in
RAID (0+1)
1-11
Configuration on Disk B-2
Configuration
Procedure: LUN
Filtering
8-20
Connecting Drives with
Fibre Channel Dual
Loop
8-10
Connection Type 8-10
Controller
Communications Over
Fibre Loops
8-12
Controller Failover and
Failback
10-9
Controller Failure 10-13
Controller Name: LCD 5-37
Controller Name:
terminal
7-37
controller naming 5-37, 7-37, 7-
39, 8-11
Controller Parameter
Settings
2-10
Controller Parameters:
LCD
5-37
Controller Parameters:
terminal
7-37
controller reset 5-35, 7-36
controller temperature
sensors
B-9
Controller Unique
Identifier
8-11
Controller Unique
Identifier: LCD
5-37
Controller Unique
Identifier: terminal
7-39
Controller Voltage and
Temperature: LCD
4-6
Controller Voltage and
Temperature: terminal
6-9
controller voltage
monitors
B-9
Controller/Logical Drive
Shutdown
B-3
Copy and Replace
Drives
12-7
Creating a Logical
Drive: LCD
5-6
Creating a Logical
Drive: terminal
7-5
Creating a Logical
Volume: LCD
5-10
Creating a Logical
Volume: terminal
7-10
Creating LUN Masks 8-15
Creating Primary and
Secondary IDs
10-22, 10-29
Cylinder/Head/Sector
Mapping
9-16
D
Dedicated
Communications loops
8-12
default setting,
restoring
5-33
Deleting a Logical
Drive: LCD
5-16
Deleting a Partition of a
Logical Drive, LCD
5-17
Deleting a Partition of a
Logical Drive: terminal
7-17
Deleting a SCSI
Channel’s ID, LCD
5-27
Deleting a SCSI ID:
terminal
7-27
Deleting Logical Drive:
terminal
7-17
deleting partition of
logical drive
7-17
deleting SCSI ID 7-27
deleting spare drive,
global or local
7-24
Deleting Spare Drive:
LCD
5-25
Deleting Spare Drive:
terminal
7-24
deleting, LUN
mappings
5-22
deleting, partition of
logical drive
5-17
deleting, SCSI channel
ID
5-27
deleting, spare drive,
global or local
5-25
Detect Only 9-9
Detect, Clone+Replace 9-10
Detect, Perpetual
Clone
9-9
Detection of Drive Hot
Swap Followed by Auto
Rebuild
9-22
detection, idle drive 9-23
To Next Page
Loading...