Compaq ProLiant 3000 Setup And Installation Guide

5-15
Compaq ProLiant 3000 Servers Setup and Installation Guide
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: F-CH05.DOC Last Saved On: 1/5/99 11:24 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Loading Compaq Device Drivers
Drivers are located on the Compaq SmartStart and Support Software CD.
IMPORTANT:
Always check README files on the SmartStart and Support
Software CD. If present, these files may contain information about important
software updates.
Novell NetWare Device Drivers from Compaq
Your server must have certain device drivers to operate using NetWare. These
drivers are located on the Compaq SmartStart and Support Software CD
shipped with the server. If you use SmartStart to install the operating system,
these drivers will be installed automatically. Otherwise, you can use SmartStart
to support a manual installation of Novell products.
For more information on these drivers, execute NSSD.HLP from the
\CPQSUPSW\NSSD directory on the Smart Start CD-ROM.
Manual installation
If you choose to configure the server without SmartStart:
1. Insert the Compaq SmartStart and Support Software CD into the
CD-ROM drive.
2. Boot your system.
3. Select Manual Installation.
4. Follow the instructions provided by the operating system that you are
installing.

Compaq ProLiant 3000 Specifications

General

Brand	Compaq
Model	ProLiant 3000
Category	Server
Language	English