5-16
Server Configuration and Utilities
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: F-CH05.DOC Last Saved On: 1/5/99 11:24 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Microsoft Windows NT Device Drivers from
Compaq
Drivers are supplied to support Windows NT 3.51 and 4.0. They are located on
the SmartStart and Support Software Diskette CD, and some of the drivers are
contained on the Windows NT retail product. These drivers are also located on
the Compaq SmartStart and Support Software CD. The drivers on the SSD may
be newer versions with new functionality, problem fixes, and so on. If you use
SmartStart to install your operating system, these drivers are installed
automatically. Otherwise, you can use SmartStart to create an Windows NT
Support Software Diskette (SSD) from Compaq to support a manual installation
of Windows NT.
For more information on the drivers, run the README.BAT file in the root
directory of the SSD for Windows NT. This will load the WinHelp file
NTREADME.HLP.
Manual installation
If you choose not to let SmartStart configure the server:
1. Insert the SmartStart and Support Software CD into the CD-ROM drive.
2. Boot your system.
3. Select Manual Installation.
4. Follow the instructions that display on the monitor.
To Next Page
Loading...
Need help?
General
