Compaq ProLiant 3000 - Chapter 5 Server Configuration and Utilities; Configuring the Server with Smartstart

5-1
Compaq ProLiant 3000 Servers Setup and Installation Guide
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: F-CH05.DOC Last Saved On: 1/5/99 11:24 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Chapter 5
Server Configuration and
Utilities
This chapter describes the tools that Compaq provides to assist you in the
configuration and management of your Compaq ProLiant 3000 Server.
Configuring the Server with
SmartStart
SmartStart is the intelligent way to configure the server and to load the system
software, there by achieving a well-integrated server are ensuring maximum
dependability and supportability. The SmartStart and Support Software CD
holds the Compaq System Configuration Utility and ROMPaq. To use the
SmartStart and Support Software CD, refer to the Server Setup and
Management Pack included in the shipping box.
To install the Compaq SmartStart and Software Support CD:
1. Turn on the computer.
2. Insert the CD-ROM into the tray, handling the CD by the edges rather
than by the flat surfaces of the disc.