Compaq ProLiant 3000 Setup And Installation Guide

5-10
Server Configuration and Utilities
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: F-CH05.DOC Last Saved On: 1/5/99 11:24 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Verifying the System Partition
To verify that the system partition exists:
1. Remove any media from the CD-ROM drive and the diskette drive.
2. Reboot the system by pressing Ctrl+Alt+Del or by turning the server
OFF and then ON again.
3. Press the F10 key when the following prompt appears.
Press "
F10
" key for System Partition Utilities
IMPORTANT:
The text appears for only two seconds. If you do not press
F10
within the two seconds, you must reboot the server.
4. If a system partition exists, the server boots to the partition. If not, a
message displays that no system partition exists.
Upgrading the System Partition
To upgrade the system partition:
1. Insert the Compaq SmartStart and Support Software CD in the
CD-ROM drive and turn on the computer.
2. Select Upgrade System Partition.
3. Select to upgrade the utilities. SmartStart copies the new utilities from
the CD to the system partition.

Compaq ProLiant 3000 Specifications

General

Brand	Compaq
Model	ProLiant 3000
Category	Server
Language	English