Compaq ProLiant 3000 Setup And Installation Guide

5-17
Compaq ProLiant 3000 Servers Setup and Installation Guide
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: F-CH05.DOC Last Saved On: 1/5/99 11:24 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SCO OpenServer and SCO UnixWare Device
Drivers from Compaq
Your server must have certain device drivers to operate under the SCO
OpenServer and SCO UnixWare 2.1 operating systems. These drivers are
located on the Compaq SmartStart and Support Software CD shipped with the
server. If you use SmartStart to install your operating system, these drivers will
be installed automatically. Otherwise, you can use SmartStart to create a SCO
UNIX Support Software Diskette (EFS) from Compaq to support a manual
installation of UNIX.
The features requiring device drivers are described in the EFS documentation.
Manual installation
If you choose not to let SmartStart configure the server:
1. Insert the Compaq SmartStart and Support Software CD into the CD-
ROM drive.
2. Boot your system.
3. Select Manual Installation.
4. Follow the instructions that display on the monitor.

Compaq ProLiant 3000 Specifications

General

Brand	Compaq
Model	ProLiant 3000
Category	Server
Language	English