Maintenance l 5-13
Cleaning the Volatile Trap on the
Demister (D600 - 1000)
1 Stop the dryer and lockout the main power.
2 Remove the thumbscrews then remove the volatile demister cover.
3 Remove the demister by pulling it out from the housing.
4 Clean the assembly using a mild soap and water. Let the assembly dry
thoroughly before installation.
NOTE: In cases of heavy volatiles, steam cleaning, pressure washing or the use of solvents, such
as acetone, may be necessary. Be sure to test a small area with the solvent you have selected to
be sure there is no adverse reaction.
5 Insert the demister carefully back into the housing, making sure to
completely push it towards the back of its housing.
6 Inspect the condition of the gasket. If it is damaged, replace the gasket.
7 Secure the cover in place using the original thumbscrews.
0
NOTE: Depending on the
build date and configura-
tion of your dryer, your
demister may be on the
right side of the after-
cooler. Removal and
cleaning procedures are
the same.
0
To Next Page