Conair Carousel Plus D Series - Connecting the Dryer to Resinworks; Connecting the Drying to the Hopper

3
Installation
Installation l 3-11
Connecting the Dryer to the Hopper
If your dryer hose connection and your hopper Heater Pack hose connection are not the
same size, you will need a hose adapter. Contact Conair Parts 1 800-458-1960.
Connecting the Dryer to ResinWorks
If your dryer hose connection and the connection on your ResinWorks sled are not the same
size, you will need to use a hose adapter. Contact Conair Parts 1-800-458-1960.
NOTE: Because the D600 - 5000 models require a separate heat source for the delivery air,
all references to this heat source will be identified as a Heater Pack, or a Conair “HTC”
(Hopper Temperature Controller). When using this dryer with an HTC, reference the User
Guide supplied with the HTC for installation instructions.
0