Replacing the Desiccant Wheel (D1300 -
5000)
(continued)
7 Place the belt on your new wheel unless you are replacing the belt at the same
time, in which case you should put the new belt on the new wheel.
8 Place a sheet of cardboard inside the housing on each side to protect the gaskets
before you insert the new wheel.
9 Place the new wheel into the housing, and then pull the pieces of cardboard out
from between the wheel and the gaskets.
10 Place the belt back around the motor, and adjust the tension as necessary.
11 Replace the wheel assembly housing sides, and the dryer side panels.
6
Troubleshooting
Troubleshooting l 6-43
To Next Page
Loading...