Troublesho oti ng l 6-31
Replacing the Heaters
Regeneration Heater Tube (continued)
6 Slide the insulation off or make a straight cut in the insulation, and
remove it from the defective heater tube.
7 Check the ID mark on the side of the heater tube for kW rating and volt-
age. The ID mark is on the outside of the tube near the end with the lead
wires.
8 Place the insulation on the new heater tube. Make sure to duct tape the
seam that was cut during removal, if necessary.
9 Install the new heater tube and secure it in place with hose clamps at the
top and bottom. Be sure the end of the heater tube with the cables is oriented
toward the bottom.
10 Connect the heater tube cables to the quick disconnect of the control box
wiring harnesses.
11 Reinstall the metal control cabinet cover using the original hardware.
12 Make sure the regeneration heater fuses are not blown before applying
power to the new heater.
13 Connect the power and start the dryer.
6
Troubleshooting
To Next Page
Loading...
Need help?
General
