Conair MDCW Carousel Plus W25 - C L E a N I N G T H E R E G E N E R a T I O N F I L T E R; Cleaning the Regeneration Filter

Cleaning the Regeneration Filter
Clogged filters reduce air flow and dryer efficiency. Cleaning frequency depends
on how much material you process and how dusty or full of fines it is.
1 To access the regeneration filter, use a
small flat screwdriver to gently pry
down on the slot in the lower right hand
corner of the filter grill while pulling out
on the bottom.
2 Remove the filter from inside the grill
and clean with soap and water.
3 Replace the filter in the grill and snap
the grill into place.
Maintenanc e l 5-9
5
Maintenance
✐
NOTE: The control cabinet must be securely closed while the dryer is in operation to
ensure that regeneration air is filtered.
CAUTION: Hot surfaces.
Always protect yourself
from hot surfaces inside
and outside the dryer and
drying hopper.