Configuring the DeviceNet Software
Gateway Parameter List
Similarly to the Modbus communications, the Common Controls parameters that
are available are stored in registers 500 to 539. The dip switches determine how
much of the list is transferred to the PLC. If the dip switch is set for ten words,
Modbus parameters 500 to 509 will be transferred to the input image of the scan-
ner. If the dip switches are set for twenty words, Modbus parameters 500 to 519
will be transferred to the scanner. See Appendix A for the actual parameters that
are available from the type of common control device that your system is using.
C-12 l De vic eN et Comm un ica tions
To Next Page
Loading...
Need help?
General
