MDCW Carousel Plus Dryer Options
• Volatile trap (use only in conjunction with aftercooler) - The volatile trap is
recommended when drying materials that produce volitales that condense into
a waxy or oily residue and/or if the material contains excessive fines.
• Precooler - The precooler reduces the temperature of air flow after the
desiccant wheel and before the process heater, enabling the dryer to control
temperatures at low setpoints (100 - 150°F {38 - 66°C}).
• Filter check - The filter check sensor will activate a passive alarm when the
process filter is clogged or needs replaced.
• Heater current monitor - The heater current monitor measures the total
amperage across both the process and regeneration heaters and the pre-deter-
mined power consumption values for the blowers and the control.
• CFM monitor - The CFM monitor measures the cubic feet per minute of air
flow across the inlet/outlet of the process blower.
• Dryer communications - Allows the dryer to be networked to industrial control
systems. DeviceNet is standard on all DC-2 models, alternate communications
are available.
2-10 l De scr ip ti on
To Next Page
Loading...
