Function
4-28 l Operati on
Control Function Descriptions(continued)
Screen
SCREEN 70
SCREEN 71
SCREEN 72
SCREEN 73
DEWPOINT
TIME DELAY 5 MIN
TIME DISPLAY
12 HOUR
UNITS
STANDARD EDIT
DATE TIME
10/25/2004 MON 10:33 AM
This is the amount of time from start-up
the dryer is allowed to run before the con-
trol will try to monitor the dewpoint. Five
minutes is the default. This gives the dryer
time to warm up and reach a steady state.
It can be changed with the proper pass-
word (see page 4-32, screen 85).
This screen shows the units the dryer will
display. It can be changed with the proper
password (see page 4-32, screen 85) to
either Standard or Metric. Press the Select
Category button below the word Edit to
change the setting and press the
“ENTER” key to lock in the value.
This screen shows the time unit the dryer
will display. It can be changed with the
proper password (see page 4-32,
screen 85) to either 12 hour (AM/ PM
Clock) or 24 hour (Military Time). Press
the Select Category button below the
words 12 hour to change the setting and
press the “ENTER” key to lock in the
value.
This screen shows the date and time. With
the proper password, (see page 4-32,
screen 85) the date and time can be
changed.
To Next Page
Loading...
