3-12 l Ins ta ll ation
Connecting the Aftercooler and
Optional Precooler (Optional)
The aftercooler and optional precooler require
2 gals./min. {7.6 liters/min.} tower, city or
chiller water and a discharge or return line.
1 Remove the two (2) screws that secure
the dryer’s plastic cover, then remove
cover.
2 Connect water fittings to the 90 degree
tubing bend of the aftercooler or
optional precooler. Seal the threads
with silicon tape.
3 Connect water supply inlet. Secure
with hose clamp.
4 Connect water supply outlet. Secure
with hose clamp.
5 Replace plastic cover, resecure screws.
IMPORTANT: Turn the water off when the dryer is not in use to prevent
condensation.
✒
TIP: Make the water supply and
discharge / return connections with
flexible hoses at least 24 in.
{61 cm} long. This allows you to
easily remove the aftercooler or
optional precooler assembly for
cleaning.
✒
TIP: If an optional flow control is
also being installed with the after-
cooler or optional precooler, the
manual shut off valve should be
installed on the inlet line for the
flow control.
NOTE: 50-100 models have four (4) screws
that secure the plastic cover to the dryer.
✐
IMPORTANT: When a precooler
is purchased instead of an
aftercooler, the precooler will be
mounted in the aftercooler’s
location.
IMPORTANT: Do not move the
Carousel Plus W series 15 -100 dryer
with the aftercooler and/or optional
precooler water hoses attached. You
must detach the water inlet/outlet
hoses and move the dryer to its new
location and then reattach the water
inlet/outlet hoses. Failure to do so will
harm your equipment.
To Next Page
Loading...
