Conair W Series - To Start Drying

When configured as a central dryer, the drying temperature
can not be set since there is no process heater in the system.
Central
To Start Drying
1 Make sure there is material in the hopper.
2 Turn on the main power to the dryer. Make sure the dryer’s disconnect dial
is in the “ON” position. This powers up the control and the display lights will
illuminate.
3 Set the drying temperature. Press the appropriate Select Category button then
the Adjust Setpoint (+) or (-) buttons or enter your drying temperature on the
numeric keypad and then press “ENTER”.
(continued)
1
2
3
4
5
6
7
8
9
Clear
0
Enter
Adjust Setpoint
Acknowledge
Alarm
Start
Stop
Select
Category
Menu
Scroll List
Prev
Next
Auto Start
Dewpoint Control
Set-Back Temp.
Process Blower
Process Heater
Regen. Blower
Regen. Heater
25
NOTE: When changing a setpoint use the Select Category Key
directly below the value to be changed. Once pressed the
value will blink, then use the keypads or (+) (-) adjustment set-
points to enter the new value. Then press “ENTER” for the
new value to be recognized.
✐
Setpoint
adjustment
buttons
Select
Category
buttons
Operatio n l 4-35
4
Operation