3
Installa tion
Installa ti on l 3-13
Mounting a Loader on the Hopper
If you have a Conair loader or vacuum receiver, you can
use the flange and mounting clips provided on the top of
the hopper. Refer to the manuals that came with your
receiver or loader for detailed installation instructions.
Testing the Installation
You have completed the installation. Now it’s time to make sure everything works.
1 Make sure there is no material in the hopper. If you have mounted a loader
or vacuum receiver on the hopper, disconnect the material inlet hose at the
source or turn the loader off.
2 Turn on the main power to the dryer. Make sure the dryer’s disconnect dial is
in the ON position. This powers up the control and the display lights will
illuminate.
3 Set the drying temperatures. Press temperature select with the select category
button, and then press the Setpoint Adjust (+) or (-) buttons or enter a low
setpoint temperature (150ºF {66ºC}) on the numeric keypad and then press
enter.
(continued)
1
2
3
4
5
6
7
8
9
Clear
0
Enter
Adjust Setpoint
Acknowledge
Alarm
Start
Stop
Select
Category
Menu
Scroll List
Prev
Next
A
uto Start
Dewpoint Control
Set-Back Temp.
Process Blower
Process Heater
Regen. Blower
Regen. Heater
25
When configured
as a central dryer,
the drying temper-
ature can not be
set since there is
no process heater
in the system.
Select Category Buttons
Setpoint Adjustment Buttons
To Next Page
Loading...
