Before Beginning
You can avoid most problems by following the recommended installation and
maintenance procedures outlined in this User Guide. If you do have a problem,
this section will help you determine what caused it and how to fix it.
Before you remove the cover from the dryer be sure to:
❏ Diagnose causes from the control panel.
1 Press once to silence the optional audible alarm and display the
alarm message.
2 Address the alarm message and fix the problem. (Refer to the alarm
descriptions later in this section.)
3 Press again to clear the alarm. If the alarm reappears the problem
was not fixed.
1
2
3
4
5
6
7
8
9
Clear
0
Enter
Adjust Setpoint
Acknowledge
Alarm
Start
Stop
Select
Category
Menu
Scroll List
Prev
Next
Auto Start
Dewpoint Control
Set-Back Temp.
Process Blower
Process Heater
Regen. Blower
Regen. Heater
25
Acknowledge
Alarm Button
Scroll List
Buttons
6-2 l Tro ub le sh oo ti ng
NOTE: Use of test
mode screens 28-43
may assist with the
determining of possi-
ble cause of an alarm.
Access code 756.
✐
To Next Page
Loading...
