5
Maintenance
Maintenance l 5-7
Cleaning the Regeneration Filter
Clogged filters reduce air flow and dryer efficiency. Cleaning frequency depends
on how much material you process and how dusty or full of fines it is.
1 To access the regeneration filter, use a small flat screwdriver to gently pry
down on the slot in the lower right hand corner of the filter grill while
pulling out on the bottom.
2 Remove the filter from inside the grill and clean with soap and water.
3 Replace the filter in the grill and snap the grill into place.
CAUTION: Hot surfaces.
Always protect yourself
from hot surfaces inside
and outside the dryer and
drying hopper.
To Next Page
Loading...
