Conair W Series - Carousel Plus W Series Dryer: Control Panel DC-2

4-2 l Opera ti on
1
2
3
4
5
6
7
8
9
Clear
0
Enter
Adjust Setpoint
Acknowledge
A
larm
S
tart
S
top
Select
Category
Menu
Scroll List
Prev
Next
A
uto Start
D
ewpoint Control
Set-Back Temp.
P
rocess Blower
Process Heater
R
egen. Blower
Regen. Heater
25
Carousel Plus W Series Dryer
: Control Panel DC-2
Start and Stop Buttons
Press “Start” to start the dryer.
Press “Stop” to stop the dryer.
Acknowledge
Alarm Button
Press once to
silence the option-
al audible alarm
and display alarm
messages. Press
again to clear the
alarm.
Status
Display
Alpha-numeric
characters
display process
and alarm
conditions.
Dr yer
Status
Illuminated
lights show
the status of
the dryer.
Enter Button
Used to lock-in
data entries.
Menu Button
Press to view the main menu screen where you can
select on screen categories or press again to return
to the default screen where process temperature and
actual setpoint are displayed. This button can be
pressed at any time to return to the default screen.
Screen Title
Alpha-numeric characters
display process and alarm
conditions.
Scroll Buttons
Press to scroll through the closed loop parameter
list. The “Prev” button scrolls the user up the
list, while the “Next” button scrolls the user
down the list to the last screen and then back to
the parameter list title screen at the top.
Numeric
Keypad
Press numbers to
enter data.
Select
Categor y
Press to select on-
screen categories,
paths and options.
Clear Button
Press to clear high-
lighted on-screen
data entry fields,
only after data has
been entered.
The clear button
clears the field one
number at a time.
NOTE: When changing a setpoint use the Select Category
Key directly below the value to be changed. Once
pressed the value will blink, then use the keypads or (+)
(-) adjustment setpoints to enter the new value. Then
press enter for the new value to be recognized.
✐
Increment/
Decrement
Buttons
Used to increase
or decrease val-
ues.