Contec SBC Series User Manual

7. BIOS Setup
PC-686BX(NLX)-LV, PC-686BX(NLX)-LVV
75
Soft-Off by PWR-BTTN
Enabling this setting causes the system to operate with very low power consumption if
the system power supply on/off button is turned off. In this state, the system only
draws sufficient power to detect power supply button activity and "ring-initiated
restart" activity.
Selection options: Instant-Off, Delay 4sec
Power On by Ring
This restarts the system if an input signal is detected on the serial RI (Ring Indicator)
line (modem receives call).
Selection options: Enabled, Disabled
Resume by Alarm
This recovers the system from the soft-off state if an input signal is detected on the
serial RI (Ring Indicator) line (that is, the modem receives a call).
Wake Up On LAN
The system can be restarted by the "Wake On LAN" function. However, on this
board this only applies to the on-board network. In this case, set to "Enabled".
Selection options: Disabled, Enabled
IRQ8 Break Suspend
Monitoring of IRQ8 can be enabled or disabled so that the system does not recover
from suspend mode.
Selection options: Disabled, Enabled
Reload Global Timer Events
Enabling this setting restarts the global timer for standby mode if an event occurs one
of the following devices.
- IRQ (3 - 7, 9 - 15), NMI - Primary IDE 0
- Primary IDE 1 - Secondary IDE 0
- Secondary IDE 1 - FDD, COM, LPT port
- PCI PIRQ[A-D] #

Contec SBC Series Specifications

General

Brand	Contec
Model	SBC Series
Category	Motherboard
Language	English