Genus G1 MARK II Users Manual
UM3010-2
QUICK CHECK
While in Quick Check mode the internal readers and wands attached to the wand port can be
tested. If there are values currently displayed, once a read takes place from a card or wand
the values in the display are replaced by the values from the card or wand read.
To enter Quick Check Press to select.
At this point, all key-presses except the key will be echoed on the screen. Up to 40
characters can be entered encompassing the lower two lines of the display. The top two
lines of the display are reserved for terminal messaging while in offline mode. Data is
displayed from the lower right-hand corner and scrolls left. The data wraps from the
beginning of line 4 to the end of line 3. In this way, the most recently pressed key is always
displayed in the last character position on the screen.
Internal Smartcard readers MIFARE and iCLASS are auto detected as the terminal powers
up and do not require configuration under “Reader Setup”. The associated badges can be
presented while in quick check to establish whether a read and a good read tone occurs.
The values returned are displayed in encrypted format.
Revision B 10-30-07 26
QUICK CHECK?
<UP><DWN><E>
QUICK CHECK?
<0-9><E><C><H>
To Next Page
Loading...