Control Module Genus G1 Mark II - BIO SENSOR TEST; Sensor Test Verification; CALIBRATE SENSOR; Sensor Calibration Procedure

Genus G1 MARK II Users Manual
UM3010-2
BIO SENSOR TEST
Verifies reader is functioning correctly.
Press to select.
The Terminal requests user to place a finger
on the sensor to test. This occurs twice to
verify the finger and complete the test. If a
new finger is used the message displayed
will be “VERIFY FAILED”.
CALIBRATE SENSOR
Generally calibration of the Biometric sensor should not be required. Contact the CMI
Service department concerning the calibration of the Biometric sensor.
Press to select.
Revision B 10-30-07 29
BIOMETRIC TEST?
<UP><DWN><H><E>
BIO SENSOR TEST?
BIOMETRIC TEST?
<UP><DWN><H><E>
BIO SENSOR TEST?
FINGER VERIFIED
BIOMETRIC TEST?
<UP><DWN><H><E>
BIO SENSOR TEST?
PUT FINGER ON SENSOR
BIOMETRIC TEST?
<UP><DWN><H><E>
BIO SENSOR TEST?
PUT FINGER ON SENSOR
BIOMETRIC TEST?
<UP><DWN><H><E>
CALIBRATE SENSOR?
DO NOT PUT FINGER...
BIOMETRIC TEST?
<UP><DWN><H><E>
CALIBRATE SENSOR?
SENSOR CALIBRATED