CONTENTSINTRODUCTIONINSTALLATION
COMMISSIONING
OPERATION
11
Commissioning
Once all necessary connections have been made to the SD3 speech dialler, clip
the cover on to the base, taking care not to trap any cables.
Getting started
When beginning a new installation, it is advisable to prompt the SD3 unit to make
a factory reset in order to ensure that any existing settings are removed.
To prompt a factory reset
1 Press and hold 9 and reconnect the power to the speech dialler. The SD3 will
display the factory-reset menu:
Factory Reset?
[ENT] or [ESC]
At this point:
• Press
E to revert to factory settings and show the Change Language screen:
Change Language?
[ENT] or [ESC]
• Press F to cancel the factory reset. The display will change to standby mode:
To change the display language
1 Following a factory reset, press E to display:
Change Language?
[ENT] or [ESC]
3 Use the
A or C scroll keys to select the language you want to use.
4 Press
E to select. The SD3 will change the display to the selected language, and
enter standby mode.
The unit is now ready for
programming and testing. Please refer to the following
pages for full details.
After the SD3 has been programmed and tested, secure the front cover with the
screws and screw caps provided.
To Next Page
Loading...