CONTENTSINTRODUCTIONINSTALLATIONCOMMISSIONING
OPERATION
32
Testing triggers remotely
You can test the SD3 unit’s response to any of the eight triggers remotely via a
telephone link.
1 Establish a
remote access connection to the SD3 unit.
2 Press
*
8 followed by 1 to 8 on your phone (depending on which trigger is to be
tested).
3 The unit will terminate your remote access call and dial the selected trigger
number.
Entering contact numbers remotely
Command
*
7 allows you to enter/change the contact phone numbers.
1 Establish a
remote access connection to the SD3 unit.
2 Press
*
7 followed by 1 to 0 (depending on which contact number is to be entered
[0 = 10]) and enter the phone number twice, each time followed by #.
Example:
Enter the phone number 01235891745 and assign it to contact 3.
*
73 01235891745#01235891745#
If the two entered sets of numbers are identical there will be a successful beep
(high pitch tone), otherwise there will be an error beep (low pitch tone).
Remotely recording and playing messages
Alarm voice and restore messages
The remote access menu allows you to record and playback alarm (and restore)
voice messages 1 - 8 (plus site message) through your telephone handset. These
are the messages that are sent to registered contacts when alarm conditions oc-
cur.
Note: The ‘Remote Access’ option must be set to ON. See ‘Programming menu >
System Options > Remote Options > Remote Access’.
To record/play a voice alarm/restore message
1 Establish a remote access connection with the SD3, as discussed earlier within
this section.
2 Select the required options, as follows:
• To record an alarm voice message: Press
*
4 followed by the voice message
number 1 to 8 on your telephone. You will hear a short beep. Talk clearly into
your telephone handset. Press 0 to stop recording.
• To play an alarm voice message: Press 4 followed by the voice message
number 1 to 8 on your telephone. The selected message will be played back
through your telephone handset. If necessary, press 0 to stop playback.
• To record an alarm restore message: Press
*
5 followed by the restore mes-
sage number 1 to 8 on your telephone. You will hear a short beep. Talk clearly
into your telephone handset. Press 0 to stop recording.
• To play an alarm restore message: Press 5 followed by the restore message
number 1 to 8 on your telephone. The selected message will be played back
through your telephone handset. If necessary, press 0 to stop playback.
3 Use your telephone to select other remote access commands or press # to hang-
up the connection with the SD3.
Memo messages
The remote access menu allows you to record and playback a memo message
through your telephone handset. The memo message can then be re-played by
another remote user or directly from the SD3 unit.
Note: The ‘Remote Access’ option must be set to ON. See ‘Programming menu >
System Options > Remote Options > Remote Access’.
To record/playback a memo
1 Establish a remote access connection with the SD3, as discussed earlier within
this section.
2 Select the required options, as follows:
• To record a new memo: Press
*
0 on your telephone. You will hear a short
beep. Talk clearly into your telephone handset. Press 0 to stop recording.
• To playback the memo: Press 0 on your telephone. The memo message will
be played back through your telephone handset. If necessary, press 0 to stop
playback.
3 Use your telephone to select other remote access commands or press # to hang-
up the connection with the SD3.
To Next Page
Loading...