CONTENTSINTRODUCTIONINSTALLATIONCOMMISSIONING
OPERATION
29
Operation
How to acknowledge a voice message
The SD3 requires a call acknowledgement in order to confirm that the recipient has
accepted the call. All contacts must be informed, both in advance and within the
voice message, that they must press number 8 on their telephone to accept a call.
If a called contact does not acknowledge an alarm call, the SD3 will proceed to
contact the next programmed number.
To acknowledge a voice message
1 When the telephone rings, answer the call as normal. Listen to the voice message
(which is repeated a number of times).
2 When you have understood the message, acknowledge it at any time by pressing
the number 8 key on your telephone. You will hear an acknowledgement tone from
the SD3 and then the unit will hang up.
3 Now take the necessary action in response to the alarm.
Aborting an alarm call
If the SD3 is accidentally triggered or you want to stop the calling sequence then
one of the following methods can be used:
Enter the user code
To abort the call sequence, enter your four-digit user code.
Note: You must program the SD3 to be able use this method,
see Acknowledge-
ment and Abort Options.
Restore the trigger input
To abort the call sequence, restore the trigger input back to its normal condition.
Normally this is a simple matter of resetting the alarm control panel. The abort
methods that can be used depend on whether the SD3 is programmed to allow
you to abort calls in this way. See Acknowledgement and Abort Options.
Recording and playing a memo locally
The SD3 has an in-built memo facility to record a voice memo message at the
keypad that can be up to sixteen seconds in duration. Once recorded, the display
will indicate that there is a memo message waiting.
To Record A Memo Message
1 Ensure the unit is in normal mode and displaying the standby screen:
To Next Page
Loading...