Cooper Menvier SD3 - Access Codes; To Change the User Code; To Change the Remote Code

CONTENTSINTRODUCTIONINSTALLATION
COMMISSIONING
OPERATION
20
Access Codes
The SD3 operation is protected by two main codes:
• The user code A 4-digit code which is required, when using the unit locally, to
gain access to the programming menus. The user code is also used for aborting
calls. The default user code is ‘1234’.
• The remote code A 4-digit code that is used, when dialling into the unit from a
remote location, to gain access to the remote access menu (see Using the re-
mote access feature). The default remote code is ‘5678’.
To change the user code
1 From standby, enter the user code, then use the scroll keys (A or C) or 4 to
display the Access Codes menu:
Access Codes
Press E to select. The screen will show: Edit User Code.
2 Press
E to select. The screen will show:
****
New User Code
?
3 Enter a new four-digit user code and press E to accept.
4 Press
F to exit this menu.
To change the remote code
1 From standby, enter the user code, then use the scroll keys (A or C) or 4 to
display the Access Codes menu:
Access Codes
Press E to select. The screen will show: Edit User Code.
2 Use the scroll key (
C) or 2 to display: Edit Remote Code.
3 Press
E to select. The screen will show:
****
New Remote Code
?
4 Enter a new four-digit remote code and press E to accept.
5 Press
F to exit this menu.