CONTENTSINTRODUCTIONINSTALLATION
COMMISSIONING
OPERATION
24
View Log
The SD3 has a time and date-stamped event log that records a range of detected
occurrences, such as power failures, date changes, trigger inputs and the recipi-
ents contacted. The log has capacity for 128 entries and retains all information
when power is removed.
To view the event log
1 From standby, enter the user code, then use the scroll keys (A or C) or 9 to
display the View Log menu:
Log entry number Event time and date
Type of event
(see opposite
for explanations)
Log event codes
Display Description
Trig A Alarm A trigger on input A to H has been sensed.
Trig A Clear Trigger A to H has returned to its normal non-alarm state.
Call 1 A call has been made to Contact 1 to 10 (the contact’s
name will be displayed if programmed).
Call PSTN (GSM) Alarm call made via fixed (or mobile) communication.
Call Fail Alarm call attempt failed.
Ack> Contact 8 The call was acknowledged by contact 1 to 10.
No Ack 8 No acknowledgement received from contact.
Abt> Contact 8 Alarm aborted (remotely by contact).
User Abort Alarm aborted (at SD3 panel).
Time (Date) Changed The time (or date) has been changed.
Temp High Alarm The pre-set temperature high has been exceeded.
Temp Low Alarm The pre-set temperature low has been exceeded.
Temp High (Low) Clear The temperature high (low) has returned within pre-set.
Line OK Telephone line operation appear to be correct.
Line Fault Telephone line unavailable for more than 40 seconds.
Line Restored Telephone line restored.
Remote Access The remote access was carried out.
Remote Start Remote call started
Remote Clear Remote call ended
Memo Left A memo was left.
Memo Cleared The memo was cleared.
GSM Sig. Low When the GSM signal level falls below the level set in
the Signal Low option.
GSM Sig. OK Mobile network signal detected.
Supply OK Power supply level is within limits.
Supply Low The power level has previously fallen below the mini-
mum required for operation.
Sys Restart The unit has been switched On.
Log Cleared The event log contents have been cleared.
Auto Report An automatic call has been made.
To Next Page
Loading...