CONTENTSINTRODUCTIONINSTALLATIONCOMMISSIONING
OPERATION
31
The remote access menu
The following commands can be selected from the remote access menu using the
keypad of your touch-tone phone:
Function Phone key sequence
Toggle output 1
*
11
Toggle output 2
*
12
Toggle output 3
*
13
Toggle output 4
*
14
Listen-in/talkback mode
*
3 then subsequently 3 to change
between listen-in and talkback
modes. 0 to quit listen-in/talk
back modes.
Play alarm voice messages 1 to 8 4 followed by 1 to 8
Record
alarm voice messages 1 to 8
*
4 followed by 1 to 8 (0 to stop)
Play restore messages 1 to 8
5 followed by 1 to 8
Record restore messages 1 to 8
*
5 followed by 1 to 8 (0 to stop)
Enter contact phone numbers 1 to 10
*
7 followed by 1 to 0 (0 = 10) and
then enter the appropriate
phone number twice, each time
followed by #. Note: If number is
entered incorrectly, the error
beep will be heard.
Test alarm messages 1 to 10 after
remote access mode is terminated
*
8 followed by 1 to 0 (0 = 10).
Playback memo 0
Record memo
*
0 then subsequently 0 or any key
to stop recording and playback.
Quit remote access menu and hang-up
#
Notes:
The ‘Remote Access’ option must be set to ON. See ‘Programming menu > Sys-
tem Options > Remote Options > Remote Access’.
If after 60 seconds no command has been selected then SD3 will hang-up the call.
Once a command has been selected, the unit remains online for 5 minutes or until
the quit remote access command is used (#).
Toggle outputs
The remote access menu allows you to change (toggle) the on/off state of the SD3
outputs 1 to 4.
Note: The ‘Remote Access’ option must be set to ON. See ‘Programming menu >
System Options > Remote Options > Remote Access’.
To toggle outputs
1 Establish a remote access connection with the SD3, as discussed earlier within
this section.
2 Press the keys on your telephone to affect the outputs, as follows:
SD3 output Press You will hear
Toggle output 1 *11 On: 1 high-pitch beep, Off: 1 low-pitch beep
Toggle output 2 *12 On: 2 high-pitch beeps, Off: 2 low-pitch beeps
Toggle output 3 *13 On: 3 high-pitch beeps, Off: 3 low-pitch beeps
Toggle output 4 *14 On: 4 high-pitch beeps, Off: 4 low-pitch beeps
3 Use your telephone to select other remote access commands or press
# to hang-
up the connection with the SD3.
Listen-in & talkback mode
The remote access menu allows you to listen-in and talk to the remote site using
your telephone handset.
Note: The ‘Remote Access’ option must be set to ON. See ‘Programming menu >
System Options > Remote Options > Remote Access’.
To Select Listen-in/Talkback Mode
1 Establish a remote access connection with the SD3, as discussed earlier within
this section.
2 Press
*
3 on your telephone. You can now listen into the premises.
3 Press
3 on your telephone to switch between the listen-in and talkback modes.
The listen-in/talkback modes can also be toggled at site by pressing E.
4 When finished press
0 on your telephone to cancel talkback mode.
5 Use your telephone to select other remote access commands or press # to hang-
up the connection with the SD3.
To Next Page
Loading...