Cornelius IDC 255 - PROGATE 2 FEATURES; Progate Portion Ice Control; Lid Dispenser Information; Straw Holder Capacity

IDC 255 Progate Drive Thru Service Manual
Publication Number: 621057419SER - 4 - © 2006-2013, IMI Cornelius Inc.
Figure 1.
Electrical Connections: 6 ft long power cord with 3-prong plug attached to dispenser.
Power Requirements: 9
.3 amps at 120 volts dedicated power supply.
Water Supply Requirements: 10
0 psi (7 bar) maximum static pressure 40 psi (28 bar) minimum dynamic pres-
sure. 3/8” minimum water line recommended.
CO
2 Requirements: 100 psi max to unit regulated to 35 psi (2.4 bar) to Progate 2 ice gate system, 75 psi (5.2 bar)
carbonator.
PROGATE 2 FEATURES
Progate Portion Ice Control Features
• 4 Programmable ice dispense sizes
• Automatic/Manual Ice Dispense Modes
• Unit Power On/Off Switch
• Programmable Agitation Time
Lid Dispenser
• 4 lid dispenser locations on the unit
• 3 Separate removable lid dispensers for small/medium, large, and extra large lids
Straw Holder
• Holds up to 140 regular sleeved straws
LID HOLDER COMPATIBILITY
The following template is a guide to validate the compatibility of the cup lids that are used with the IMI Cornelius Lid
Dispensers supplied with the IDC255 Progate Ice Drink Dispenser. The lid dispensers accommodate small lids
3.75" in Dia. ± .032" in the large lid dispensers. The templates below are to scale to check the lids or compatibility.
20.756
39.750
36.901
30.000
PCX OUT OF RATIO LABEL
CORNELIUS
LOGO
UNIT
SERIAL NUMBER