What to do if the agitator does not turn in my Cornelius IDC PRO 255?
- SShane LopezDec 1, 2025
If the agitator in your Cornelius Beverage Dispenser isn't turning, first check if the unit has power and restore it if necessary, or plug in the unit. Ensure the upper ice chute assembly is properly installed and operating correctly. If the reed switch is inoperable, replace it. A defective electrical board driver circuit may also be the cause, requiring replacement of the main control board. If the gear motor has an open circuit, replace the gear motor. Also, make sure the tongue of the upper chute engages into the back of the lower chute, ensure the upper chute engages outside the lower chute, and snap the front of the chute into place. Check for a broken wire in the 2-wire harness leading to the reed switch; repair or replace the harness if needed. Repair any bad connections at the mai...















