Wavecard-Waveport User Manual Coronis Systems
2.3.3 Service commands
Service commands are used to configure a Wavecard or to read radio parameters independently of the
connected host equipment.
When a Wavecard recognizes a service command, no data is sent to the connected host. These commands
are mainly used to handle:
• Detection of remote RF modules
• Link budgets with respect to remote modules (RSSI level detection)
• Setting parameters via RF
The details of the frame format and its usage are described in chapter 4.
CS-SUP-MUTI-WPORTAPP-E04 14
To Next Page
Loading...