Coronis Wavenis Wavecard User Manual

Wavecard-Waveport User Manual Coronis Systems
5.4.6 Using selective and non-selective broadcast modes
There is no specific procedure for initiating a broadcast request in selective or non-selective modes. You just
have to make sure that remote modules have their GROUP_NUMBER parameter configured.
Simply issue a broadcast request (with or without waiting for responses) with “group number” configured to
adjust selection.
• Group number = 0xFF 0xXX 0xXX 0xXX 0xXX 0xXX non-selective mode
• Group number = 0x01 0xXX 0xXX 0xXX 0xXX 0xXX selective mode
In the second case (selective mode), all Wavenis modules within radio range whose group number is set to
0x01 will receive the broadcast command.
CS-SUP-MUTI-WPORTAPP-E04 63

Coronis Wavenis Wavecard Specifications

General

Brand	Coronis
Model	Wavenis Wavecard
Category	Microphone system
Language	English