Wavecard-Waveport User Manual Coronis Systems
Exchange with radio acknowledgement
Example of parameter configuration for wake-up management
In this example, the transmitter sends data to the receiver quickly between two relatively long
idle periods:
1) Send a parameter modification command to the receiver to modify its WakeUp period to
0 (nearly constant reception).
2) Set the transmitter's WakeUp_Length parameter to 40 ms.
3) Send the data to the receiver.
4) Send a parameter modification command to the receiver to set its wake-up period to 10 s
(default value).
5) Set the transmitter's WakeUp_Length parameter to 1100 ms (default value).
3.3 Configuring control parameters
Control parameters are used to:
• Modify RF and serial communications
• Retrieve information about the local module and communication quality with a remote module
CS-SUP-MUTI-WPORTAPP-E04 22
To Next Page
Loading...