Coronis Wavenis Wavecard - Example of Point-To-Point Request; Response Exchange

Wavecard-Waveport User Manual Coronis Systems
Case where WakeUp is too long (much higher than the receiver's WakeUp period):
3.2.3 Example of point-to-point request / response exchange
When using a point-to-point (request/response) exchange, the request is transmitted in the same manner as
before. However, in this case, the transmitter waits for a response after sending the data. The time-out period
for this can be configured using the RADIO_USER_TIMEOUT parameter (0x0C).
After processing the request, the receiver returns its response by using a specific WakeUp preamble, called
short WakeUp (Long WakeUp is not applicable since the transmitter is already in the receiving phase).
Exchange without radio acknowledgement:
CS-SUP-MUTI-WPORTAPP-E04 21