COVANA EVOLUTION COVER - Page 77

EVOLUTION COVER page-75
PROBLEM PROBABLE CAUSES SOLUTIONS
The middle sleeve
has gripped and
might have dropped
abruptly
l
Posts are frozen.
l
The stopper kit is broken/missing.
l
Verify the position of the all- weather seal.
While cover is closed, it must be sitting on the
top of the outer sleeve.
l
Check whether the stopper kit is
broken/missing.
l
Reinstall the sleeves.
l
Check level on 2 faces of the sleeve.
l
If all previous attempts failed, contact your
local authorized Covana dealer.
Escape hatch
doesn’t open/close
l
Mechanism is jammed.
l
Verify the position of the locking
mechanism.
l
Refer to the USING THE ESCAPE HATCH
section.
l
Remove the escape hatch from the underside
of the cover and clean it to free the mechanism.
l
If all previous attempts failed, contact your
local authorized Covana dealer.
The cover raises
unevenly.
l
The chain is broken.
l
A spring pin is broken.
l
A drive shaft has fallen off.
l
Posts are gripped.
l
Call your local certified Covana dealer for
technical support.
l
Do not operate the cover.
Cover raises but
does not lower.
l
The cam plate is incorrectly
positioned or missing.
l
The key switch is faulty.
l
Limit switches cannot move
properly.
l
Remove power before performing any electrical
work.
l
Ask a certified electrician only. Open the
operator and check for faulty up and down limit
switches.
l
Check if there is any corrosion on the terminals
and clean it if necessary.
l
Open the key switch and check for faulty
switch.
l
Check if any electrical cables are damaged or
pinched.
240799 OWNER'S MANUAL REVISION 4