Force FX Electrosurgical Generator C Service Manual 7-1
Replacement Procedures
Follow the procedures in this section when you need to replace the parts listed
below:
• Battery for battery-backed RAM
• Control board
• Display board and seven-segment LEDs
• Fan
• Footswitch board
• Front panel
• Front panel components, including the REM module and power switch
• Fuses, including two in the fuse drawer and one on the Power Supply/RF board
• Heat sinks (left front, left rear, and right heat sinks) and associated heat sink
components
• Low voltage power supply
• Power entry module
• Power Supply/RF board.
For your reference, this section also includes an electrical cable interconnect
diagram that illustrates all cable connections.
The parts used in these procedures are illustrated in Chapter 9, Service Parts.
Chapter 7
To Next Page
Loading...
