WARNING
TO AVOID THE POSSIBILITY OF A FIRE HAZARD, DO NOT STORE ANYTHING OR ALLOW
DEBRIS OF ANY KIND TO ACCUMULATE IN THE BOTTOM OF THE MACHINE, IN THE
BOTTOM OF THE SERVICE AREA, IN AND AROUND THE REFRIGERATION COMPARTMENT
OF THE CABINET, OR IN FRONT OF THE EVAPORATOR AND CONDENSER COILS.
INSTALLING PRICE LABELS
Pricing labels when ordered will be included with additional parts, labels, and information placed in Tray “B” during
shipment. Remove the pricing label sheets from the Tray and gently remove the label corresponding to the vend
price of each selection by tearing at the perforation. The label is installed at the top of the front knuckle. Once
installed, push the label firmly against the front of the knuckle. This will insure the label is locked in place.
INSTALLING PRODUCT ID CARDS
To assist with consistent loading, product ID cards can be installed in the product pusher to designate to the route
driver which product the column is set for. To install the flavor card, simply detach it from the sheet at the
perforation and slide it into the slots in the product pusher. Contact your graphics supplier to purchase as needed.
COIN CHANGERS & OTHER ACCESSORIES
The Vender can have an MDB Coin Changer installed and can have an MDB Bill Acceptor installed as well. Note:
BevMax Refresh 4 Models 5800-4/3800-4 will work with an MDB Bill Acceptor only. If the MDB Coin Changer and
other MDB accessories are not factory installed, refer to the instructions received from the manufacturer of the
MDB Coin Changer and other MDB accessories for proper set-up and installation.
The Vender will support the following Domestic MDB Coin Changers:
All available CPI/MEI MDB
All available Conlux MDB
All available NRI MDB
All available Coinco MDB
The Vender will support the following Domestic MDB Bill Acceptors:
All available CPI/MEI/Mars MDB
All available Conlux MDB
All available Cashcode MDB
All available Coinco MDB
The Vender will support MDB Card Readers.
The Vender supports Swipe/Tap for Cashless Vending.
“Select then Pay” workflow for purchasing product is also implemented for both Cash and Cashless operations.
SETTING THE TEMPERATURE CONTROL
This Vender is equipped with an electronic Encapsulated Temperature Sensor. Defrost is controlled both
electronically based on run time of the compressor and with a manual Defrost Thermostat. The Temp Sensor is
factory pre-set to maintain a cabinet temperature of 37º Fahrenheit (2.7ºC). It is also a good practice to ensure
the proper operating temperature prior to installing the Vender on location. To set the temperature, apply power
To Next Page
Loading...
Need help?
General
