Crane BevMAX Refresh 4 - Selection Will Not Vend

Page 43 of 52
SELECTION WILL NOT VEND
Loose
connections.
Defective
Plunger arm.
Defective
Harness.
Check Price, reset as needed.
Check Price, ensure credit is = to or
greater than price set.
Selection will
not vend.
Vend Price set
incorrectly.
Insufficient
credit.
Check Gate & factory set up
recommendations for package.
Product & Gate
mismatch.
Move product away from Gate and use Test
Vend to check Gate operation. Check for bent
pins. Use small amount of WD-40 on pins and
recheck. Replace Gate as needed.
Clean, lubricate, check for flash,
replace Slide Assy.
Gate sticking.
Dirty / Worn
Tray Slide
Assy.
Check Harness connections at VMC, Cup
Motor Board, Port Board, X & Y Motor
Boards, & X & Y Motors.
Use Vend Test to check Plunger arm,
replace Cup Assy. as necessary.
Cabinet
Peripheral
Control Board
Status Lights.
Check Cup Motor Board, Port Board, X & Y
Motor Boards Green Status Lights are blinking.
If only one is On or Off, replace the Off
Peripheral Control Board(s).
Replace Harness.