Creality K2 Plus - Fcc Warning

Select the bound printer;
FCC WARNING
This device complies with pa 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful inteerence, and (2) this device must accept any inteerence received, including inteerence that may cause undesired
operation.
Any changes or modications not expressly approved by the pay responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Pa 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful inteerence in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inteerence to radio communications.
However, there is no guarantee that inteerence will not occur in a paicular installation.
If this equipment does cause harmful inteerence to radio or television reception,which can be determined by turning the equipment o and on, the user is
encouraged to t to correct the inteerence by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierentfrom that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.