Chapter 6. Sale Operation
6.1 Preparation work
1. Make sure all the programming information have been finished. Please
check chapter 5 Basic Information setup.
2. Make sure the paper have been installed correctly.
3. Make sure the time and date have been setup. If need to change the time
and date, please check “4.1.1 Date& Time setup”
6.1.1 Clerk Sign-on
Each clerk should sign on before registration to ensure that sales data in
his/her clerk memory is recorded correctly.
Note: Please be sure you have done the clerk setup.
Operation: Input the clerkr code →【SBT】→ Input the password →【SBT】
6.2 PLU
6.2.1 Enter PLU
There are three ways to enter a PLU.
1. Bar Coded PLUs which are PLUs programmed to be registered by scanner.
Operation:
R position→ scan the PLU
2. Fast PLU keys are keys which are allocated to the keyboard.
3. Code Entry PLUs are any PLUs which are not allocated to a key on the
keyboard.
Operation: Enter the PLU code and then press【PLU】key while the control
key is at the R position. R position → PLU code →【PLU】
6.2.2 Manual Price Entry
A preset price for a PLU maybe over-ridden with a manually entered price.
Note: Please be sure the PLU flag1, ABCD, A=0, so that the PLU can change
the price. If A=4, the PLU could not change price. Or you can choose “Y” in
“change price” option when program a PLU.
To Next Page
Loading...