Chapter 7. Reports
Report Introduction
There are two modes for reports printing: X mode and Z mode.
IMPORTANT:
Z mode reports data will be cleared automatically when you printed out while
the X mode reports data will be cleared at the same time.
X mode reports data will not be cleared until the Z mode reports are printed
out.
Please check 4.1.2 System Parameter setup Table 4-1, Parameter 17 setup.
7.1 E-Journal checking
There are three ways to check the e-journal. Put the key in Z position, “Z
E-Journal”, you can see, “ by period, by bill no., and find all”
1. By time period
The time period should be input 14 characters, such as 12th June 2022,
please input 202206120000.
Then press【SBT】to look through; 【-】to print; and【CASH】to return.
To Next Page
Loading...
