Crossfire X400 - Engine Oil and Oil Filter

8-8 Periodic Maintenance and Adjustment
Engine oil and oil filter
Always check the engine oil level before
each starting. In addition, the oil and the oil
filter must be changed and replaced at the
intervals specified in the periodic
maintenance and lubrication chart.
Checking the engine oil level
1. Place the ATV on a level surface.
2. Start the engine, warm it up for several
minutes, and then turn it off.
3. Wait a few minutes until the oil settles.
4. Remove the engine oil filler cap and
clean the dipstick.
5. Insert the dipstick into the receptacle (no
need to tighten), then take the dipstick out
to check the oil level.
1. Engine oil filler cap
NOTE:
The engine oil should be between the
minimum and maximum level marks.