Operation 6-9
between zero and 25 hours.
Always read and follow the below
instruction. Since the engine is brand new,
you must not put an excessive load on it for
the first several hours of operation.
During the first 25 hours, various parts in
the engine wear and polish themselves to
the correct operating tolerances.
During this period, full throttle operation or
any condition which might result in
excessive engine heating must be avoided.
Each full throttle acceleration should be
followed with an enough rest of the engine
at lower rpm, so the engine can rid itself of
the temporary heat. If any abnormality is
noticed during this period, consult a dealer.
0-10 hours:
Avoid continuous operation above half
throttle. Allow a cooling down period of five
to ten minutes after each operation. Vary
the ATV speed from time to time. Do not
operate it at one throttle position.
10-25 hours:
Avoid prolonged operation above 3/4
throttle. Rev the ATV freely but do not use
full throttle at any time.
After break-in:
The vehicle can now be operated normally.
Braking system break-in
Applying the brakes 50 times with varying
pedal force. Each of the 50 times brakes
should be applied frequently during the
To Next Page
Loading...
